Resso Plast road marking paint consists of cold acrylic resin, colored aggregate, filler material and etc. Cold solvent pavement marking paint (white/yellow) is suitable for application to bituminous and concrete roads. It can be successfully applied to airless or air auxiliary spraying equipment.

Standard Colours:

  • Oxide red (±RAL3011)
  • Signal red (±RAL3001)
  • Traffic green (±RAL6024)

Reflection:

There are sufficient pellicle-spraying high- quality glass micro -beads with stable reflection.

Reconstruction:

There is no need to clean the old road marking paint, the reconstruction is convenient. Construction: The construction is simple, the energy consumption is less.

Features:

  1. Quick-drying
  2. Good adhesion
  3. Abrasion resistance
  4. Brightly colored, high visibility
  5. Strong weather resistance
  6. Water resistance

Technical Characteristics:

  • Viscosity : Thick fluid compound
  • Density : Approx. 1.8 gram/cm3
  • Skid resistance : > 45 S.R.T.
  • Hardening time : Approx. 20 minutes by 30°C I Approx. 30 minutes by 20°C I Approx. 40 minutes by 10°C
  • Flash point : Approx. 10°C
  • Storage stability : At least 6 months if stored in a cool place
  • Mixing ratio : 1 sachets of hardener to 10 kg Resso Plast Roll on base
  • Potlife (mixed) : 10 minutes by 20°C

Application Method :

Mark out the surface, which has to be done, with self adhesive tape. Mix the rolcoating with hardener and divide the material equally over the whole area. Immediately after application the tape can be removed. Approx. 1,5- 2,0 kg/m2at 0,8 -1,2 mm thickness should be spreading rate. Minimum application temperature 10°C. On dusty and sucking surfaces or fresh bituminous surfaces, we advise to apply PRIMER first. Weather Conditions minimum application temperature is 10°C. Clean with Thinner recommended by Duskline. for handling see material safety data sheet